E37 V-Berth
Date: January 3, 2000
From: Dale West dale.c.west@boeing.com
Paul,
This may sound like a silly question but, I want to know how the fwd area of the "A" plan E-37 converts into a berth. The table does not seem to drop or be sturdy enough to support much weight. Is there another insert to be put in place? Just how does that work?
Date: January 4, 2000
From: John Witanowski slipf18@atl.mindspring.com
Dear Dale,
The table is indeed designed to lower and rest (in the open position) on the edge of the forward bunk/settees. Your model should also be equipped with cushion inserts that fill in this area, making the dining area into a large bunk. There should be adjustable stanchions as part of your galley table. If not, they are readily available and easy to install.
Date: January 5, 2000
From: Steve Sloop sloop@home.com
Dale,
In my boat the table sides fold down then the two pedestals lower to place the table below the height of the settees. Then we have three pieces of plywood that are cut to cover between the settees. Then there are two cushions to make the big berth we call the playpen.
Date: January 5, 2000
From: Art Terwilliger Atwig@aol.com
Dale
The table has two sets of legs. A long set when used as a table and a short set when used as a berth. The table will not support your weight when used as a berth without the short set of legs.
Date: January 5, 2000
From: Carl Hibbard Chgypsy@aol.com
. . . The answer to his question is that you use two short pieces of post (about 16") when the table is used as a berth, these were probably part of the original equipment (?).
As an additional note; If someone goes looking for new or replacement posts in aluminum. Be sure to specify "Pipe", if you go looking for tubing its not available in the sizes required.
Date: January 6, 2000
From: Dale West dale.c.west@boeing.com
John,
Thanks for the reply! My boat currently has a pair of long non-adjustable legs that support the table. I will either locate a pair of telescoping legs or fabricate a second, short set.
